Step 27: Windows
8 setup feel you have a demo of the new interface. Shows you how to hit the
edge of the screen brings up the Charm bar. Using the Charm bar you can do a
search or change your settings. It also shows how you can hover your mouse at
the bottom or the top left corner to access the switch list. This list shows
all open applications and allows you to switch between them.
Step 28: Means
and ends show window moves into the final stage setup.
Step 29: Finally,
the planning process is complete and you are presented with a completely new
and unfamiliar Metro user interface. You need a common application directly in
front of you. Clicking on tile will launch these programs. At this point you
can start using your computer. However, it can not be fully configured. You
need to make sure that all hardware is detected properly and the necessary
device drivers are installed. This can be done from the Device Manager.
Step 30: In the
Device Manager click the search bar on the right charm. Then type devmgmt.msc.
Click devmgmt icon on the left.
Step 31: You'll
see all the hardware listed as shown below. You need to check if you have any
yellow exclamation mark next to the name of the devices, similar to "Base
System Device" in the figure below. This indicates that the driver has not
been installed for this device.
At this point you can install the drivers for this device.
To do so, right mouse click on the Base System Device -> Update Driver
Software ...
Step 32: You can
choose to "Search automatically for updated driver software" or
"Browse my computer for driver software". If you are a driver or CD
driver is on a USB drive and then select "Browse my computer for driver
software". Window 8 will search and install the driver from the CD or you
can locate the driver manually.
Once you have removed all the yellow exclamation marks from
the device manager Windows 8 installation was complete.
No comments:
Post a Comment